Easter Egg programming question

Post tips/tricks or get help with configuring RetroPie
Post Reply
User avatar
Posts: 218
Joined: Mon Jun 06, 2016 4:13 am
Has thanked: 23 times
Been thanked: 7 times

Easter Egg programming question

Post by joe7dust » Sat Jun 18, 2016 9:41 am

How difficult would it be to run a command if a certain series of buttons were to be pressed in a certain order? Would it be much easier to bind a hidden switch instead?

Ideally running on stock RetroPi but I'd be open to running retropi on another flavor of linux if that would be required and possible!

User avatar
Posts: 131
Joined: Wed Jun 01, 2016 11:35 am
Has thanked: 4 times
Been thanked: 30 times

Re: Easter Egg programming question

Post by Oxodao » Mon Jul 04, 2016 5:20 am

If you are using an Arduino that would be pretty easy, just with some if and a state variable, then when your series of press are done, send a uart message :)
Arduino sketch for the gamepad (Teensy replacement): http://github.com/oxodao/GBZGamepad

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest