Spooky Arduino Eyes
Spooky Arduino Eyes
I have all the materials and the 3d printed parts done to make the spooky Arduino Halloween eyes. I am very much so a newb when it comes to Arduino and github. How do you go about setting the code up on the ItsyBitsy M0 Express from the github code put that was altered by wermy? I have Ran a couple of codes on the boards to make sure I had the software on my pc correct. I see that the uncanny eyes from Adafruit has a great run down and I follow it but would like to not have to alter as much code if wermy has already done a lot of the work. Thanks for any help and sorry if this is a silly question.
- wermy
- Site Admin
- Posts: 1346
- Joined: Tue May 03, 2016 8:51 pm
- Has thanked: 620 times
- Been thanked: 1322 times
- Contact:
Re: Spooky Arduino Eyes
Hi,
So you're able to run code examples, but not the code from my uncanny eyes fork? What errors are you getting?
So you're able to run code examples, but not the code from my uncanny eyes fork? What errors are you getting?
Who is online
Users browsing this forum: No registered users and 1 guest