Page 1 of 1
[Eagle] Footprint of Raspberry Pi Zero with Bottom Pads
Posted: Fri Mar 17, 2017 2:46 pm
by VitaliBR
Hi everyone,
After searching for a Raspberry footprint for the EagleCad and finding only that it has no bottom pads (and I need with bottom pads), I decided to create my own footprint.
I uploaded it to my github, here is the link:
https://github.com/vitalibr/rpi-zero-eagle
Enjoy!
Re: [Eagle] Footprint of Raspberry Pi Zero with Bottom Pads
Posted: Wed Apr 26, 2017 8:16 am
by Woozer
Awesome, i'll test the footprint.
Hmm, pin 1 should be above the SD testpads? Doesn't look right.
Re: [Eagle] Footprint of Raspberry Pi Zero with Bottom Pads
Posted: Fri Jan 05, 2018 8:27 am
by 32teeth
This is great work!
Recommendations
1. mirror the tDocu (51) layer to bDocu (52)
- tDocu (51) mirrored to bDocu (52)
- Screen Shot 2018-01-05 at 10.25.42 AM.png (335.33 KiB) Viewed 18810 times
2. 2x20 header... ...square via the correct end
- square via on bottom right of header
- Screen Shot 2018-01-05 at 10.28.46 AM.png (97.54 KiB) Viewed 18810 times
3. PP5 isn't used by most Gameboy Zero builds, you can get rid of it
- PP5 removed
- Screen Shot 2018-01-05 at 10.54.56 AM.png (330.12 KiB) Viewed 18808 times
4. You can additionally get rid of the HDMI test points (39,36,20)
5. Labels are nice
Drill holes are removed as this will impact your design as well
- Screen Shot 2018-01-05 at 11.11.00 AM.png (249.8 KiB) Viewed 18807 times
Reference
- reference
- Raspberry-Pi-Zero-Back.jpg (356.49 KiB) Viewed 18810 times