Soldering to leads

Raspberry Pi hardware discussion (including peripherals)
Post Reply
Posts: 4
Joined: Sun Jan 08, 2017 1:21 am
Been thanked: 1 time

Soldering to leads

Post by furikazashi » Sat Oct 14, 2017 1:27 pm

I have a Raspberry Pi project I'm working on with the Gameboy Pocket version however I'm attempting to uncovered traces on the Gameboy Pocket lower-end where the controls are at. Below is a picture of my control board can anyone highlight areas for me or make arrows pointing to the exact areas that are recommended for uncovering traces? I have already separated the left from the right half by cutting the traces there
IMG_20171013_192348.jpg (3.9 MiB) Viewed 2073 times

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest