How to wire up Arduino?
Posted: Tue Dec 27, 2016 2:42 pm
Hi,
This is the first time I work with PCB's and stuff, so I'm pretty much a newbie.
I purchased the Arduino Pro Micro instead of the Teensy LC. I have a few questions:
1) How do I connect the board via USB-cables (red, black, green, white) in the GBZ? Which pins on the board do I have to use for that?
2) There are 3 ground-pins on the board. Which do I have to use for what?
3) Is there anything else, I have to keep in mind when setting the hardware up? (Software is already flashed on the Arduino)
Here's a picture of the board.
Thank you in advance!
Freddy
This is the first time I work with PCB's and stuff, so I'm pretty much a newbie.
I purchased the Arduino Pro Micro instead of the Teensy LC. I have a few questions:
1) How do I connect the board via USB-cables (red, black, green, white) in the GBZ? Which pins on the board do I have to use for that?
2) There are 3 ground-pins on the board. Which do I have to use for what?
3) Is there anything else, I have to keep in mind when setting the hardware up? (Software is already flashed on the Arduino)
Here's a picture of the board.
Thank you in advance!
Freddy