Page 7 of 7
Re: How to Program Helder's All in One GBZ PCB with Arduino IDE
Posted: Fri Dec 28, 2018 1:47 am
by Macx
Thanks for pointing out
, I've swapped the USB pins and now it's only recognized as a USB HUB. I have no possibility to install another driver. What am I still doing wrong? Thank you in advance
Re: How to Program Helder's All in One GBZ PCB with Arduino IDE
Posted: Fri Dec 28, 2018 11:39 am
by Helder
Macx wrote: ↑Fri Dec 28, 2018 1:47 am
Thanks for pointing out
, I've swapped the USB pins and now it's only recognized as a USB HUB. I have no possibility to install another driver. What am I still doing wrong? Thank you in advance
So it shows up as a usb hub? the nthat part is working but nothing else is showing up? like does it show a Leonardo USB GamePad? also where did you buy the board from? I haven't sold these in well over a year but RGN has been selling them and if you got them from him I'd ask for an exchange if the Atmega32u4 is not being recognized.
Might want to invest in a cheap $4 USBasp programmer to reprogram the MCU if it needs it.
Re: How to Program Helder's All in One GBZ PCB with Arduino IDE
Posted: Sat Dec 29, 2018 1:06 pm
by Macx
Helder wrote: ↑Fri Dec 28, 2018 11:39 am
Macx wrote: ↑Fri Dec 28, 2018 1:47 am
Thanks for pointing out
, I've swapped the USB pins and now it's only recognized as a USB HUB. I have no possibility to install another driver. What am I still doing wrong? Thank you in advance
So it shows up as a usb hub? the nthat part is working but nothing else is showing up? like does it show a Leonardo USB GamePad? also where did you buy the board from? I haven't sold these in well over a year but RGN has been selling them and if you got them from him I'd ask for an exchange if the Atmega32u4 is not being recognized.
Might want to invest in a cheap $4 USBasp programmer to reprogram the MCU if it needs it.
hello helder, I have the board directly from you (2017) ... that's all a while ago, I had a few private problems and often have to pause. yes you are right, only the usb hub is detected no gamepad or sound card. ... how big is the chance that it works with the programmer, then I buy me such a thing
thank you
Re: How to Program Helder's All in One GBZ PCB with Arduino IDE
Posted: Sat Dec 29, 2018 5:05 pm
by Helder
Worth a shot and the programmer can be used for other boards that have similar arduino chips so it's not a waste of money.
Re: How to Program Helder's All in One GBZ PCB with Arduino IDE
Posted: Sat Jan 05, 2019 12:51 pm
by Macx
Hello everybody, I get this error. Is the board broken now, or do I have a chance to repair it?
BTW, Happy New Year
Re: How to Program Helder's All in One GBZ PCB with Arduino IDE
Posted: Sun Jan 06, 2019 4:47 pm
by Helder
You sure you have it connected properly to the board? also hit the detect button first to see if it detects the atmega chip or not. If you wire it wrong then you may have damaged it especially if it was working at one time.
, I've swapped the USB pins and now it's only recognized as a USB HUB. I have no possibility to install another driver. What am I still doing wrong? Thank you in advance 