SNES Buttons
-
- Posts: 26
- Joined: Thu May 05, 2016 3:51 am
- Location: Rotterdam
- Has thanked: 5 times
- Been thanked: 3 times
- Contact:
Re: SNES Buttons
In used original snes buttons. They look just a little bit smaller than the dmg ones.
- Attachments
-
- image.jpeg (1.71 MiB) Viewed 5133 times
- Kilren
- Posts: 574
- Joined: Wed May 11, 2016 4:40 pm
- Location: Washington, USA
- Has thanked: 35 times
- Been thanked: 84 times
Re: SNES Buttons
I bought a non oem shell that was suppose to be same spec. It's possible that they're smaller.alien0matic wrote:I could have sworn that the GB buttons were 10.5. I'll measure again!Kilren wrote:Kilren wrote:
The buffalos measured 9.95mm and the GB buttons were 10.05mm No enough difference to make a difference.
- skrapps914
- Posts: 184
- Joined: Sat May 28, 2016 8:14 pm
- Has thanked: 63 times
- Been thanked: 33 times
Re: SNES Buttons
i also bought a replica shell, and its a bit smaller. when i put the controller pcb in, on the left, the tab that goes through the hole to hold it in place, is significantly shorter than the original one as well.Kilren wrote:I bought a non oem shell that was suppose to be same spec. It's possible that they're smaller.alien0matic wrote:I could have sworn that the GB buttons were 10.5. I'll measure again!Kilren wrote:
-
- Posts: 10
- Joined: Tue Aug 30, 2016 2:46 am
- Location: Germany
- Has thanked: 1 time
- Been thanked: 5 times
Re: SNES Buttons
the china clone snes pads have buttons which not fit.
so, get an original snes pad or cloned DMG01 buttons. they fit!
more infos:
http://www.objectproject.net/zeroboy/bu ... urchmesser
so, get an original snes pad or cloned DMG01 buttons. they fit!
more infos:
http://www.objectproject.net/zeroboy/bu ... urchmesser
Who is online
Users browsing this forum: No registered users and 1 guest