My MintyPi Build Log + Parts List

[ProfessorZ]

Black with red buttons looks really slick.

Unfortunatly I only have black buttons.

[ProfessorZ]

Is it possible to spray paint the buttons...

[YaYa]

Yes sure it’s possible ! Depending on which paint can you ise, it may however maybe not stick well. I recommend using RC Body Car painting as they are very elastic and stong, they won’t fall off peeling

[ProfessorZ]

Yes sure it’s possible ! Depending on which paint can you ise, it may however maybe not stick well. I recommend using RC Body Car painting as they are very elastic and stong, they won’t fall off peeling

It won’t make it too thick though right?

[YaYa]

Cans like those from Tamiya will deposit only a few microns but of course, your gesture must start out the button and finish out the button so you do not deposit a pack of painting on it...
Between each layer, allow one hour drying... 2 layers should be enough if well done

Watch some RC Body painting techniques videos to see what i’m talking about

[ProfessorZ]

Cans like those from Tamiya will deposit only a few microns but of course, your gesture must start out the button and finish out the button so you do not deposit a pack of painting on it...
Between each layer, allow one hour drying... 2 layers should be enough if well done

Watch some RC Body painting techniques videos to see what i’m talking about

Is this any good?
https://www.amazon.co.uk/gp/product/B00 ... 1OLE&psc=1

[YaYa]

Sounds good but cannot guarantee how strong it is...
Inwould recommend this one which is proven over many years by the RC drivers community

https://www.amazon.co.uk/gp/aw/d/B000BN ... ref=plSrch

[ProfessorZ]

Looks good but it’s expensive, what happens with the writing on the buttons?

[YaYa]

They will be covered

[ProfessorZ]

They will be covered

I'll use black on black then I'll try and get red buttons at some point.