My MintyPi Build Log + Parts List

[abrugsch]

And from the guide that you've told me you've read (and can solder)

Flux
So the key thing of a good solder joint is heat right? If everything is hot enough that's all that's important right?
Well heat is important but not the end of the story. The bond surfaces also have to be clean otherwise the solder won't flow. This doesn't mean you need to scrub your components and PCB's before you use them (though sometimes you might need to remove severe oxidisation with a light abrasive such as a fibreglass pencil) But this is where the magic of flux comes in. As mentioned in part one, most reel solder comes with flux built in which melts with the solder. The melted flux then flows faster than the solder into all the channels and cleans as it goes, providing a platform for the solder to bond to. HOWEVER, the flux is only good for a couple of seconds before it burns away completely.

[ProfessorZ]

Thanks a million!!!

[abrugsch]

In the desoldering situation, flux helps the excess solder drag off the pins leaving just a clean joint

[ProfessorZ]

Just ordered that flux you gave me the link for, will add it to my equipment list!

[ProfessorZ]

Battery has been ordered! If it comes and isn't on fire I will add it to the parts list... If it explodes on the plane, I could be put on the terrorist list.... Which isn't ideal...

[ProfessorZ]

I'm now putting the games on the Micro SD Card. Hopefully, it will go well!

[ProfessorZ]

Multimeter has arrived! Getting beeps on everything however on the cs I am getting no beeps and a reading of 436. Any ideas?

[ProfessorZ]

Problem Fixed!!! All connections are solid and look good,just need a battery charger and a new screen!!

[Helder]

Wow see what real equipment can do? Beats that led tester huh.

[Lphillimore]

Wow see what real equipment can do? Beats that led tester huh.

We do not speak of that LED tester.