Looks dope!
Just one question.
If I buy the PCB do I still need to buy the ds lite buttons + conductive pads or just the buttons?
Looks dope!
wermy wrote: ↑Tue May 09, 2017 5:48 pmI use PLA for the main colored part with the buttons, as well as the bezel. I use a PC/PBT blend that is much stronger for the hinge and anything with screw holes.
Edit: I use these guys - I've had great luck with them: https://www.pushplastic.com/collections
There is a piece that goes behind the screen bezel, and a piece that goes below the buttons and everything (what holds the powerboost, L/r buttons and battery in place). Those are the parts that the screws actually go into, so I use the PC/PBT for those.Danv97 wrote: ↑Tue May 09, 2017 10:09 pmwermy wrote: ↑Tue May 09, 2017 5:48 pmI use PLA for the main colored part with the buttons, as well as the bezel. I use a PC/PBT blend that is much stronger for the hinge and anything with screw holes.
Edit: I use these guys - I've had great luck with them: https://www.pushplastic.com/collections
So you use PLA for the bezel around the screen and the cover around the buttons but were do you use the PC/PBT if both the bezel and the cover around the buttons both have screwholes?
Thanks for the answer!
I used ebay to buy the battery and PB500C since shipping is cheaper an is also available and is the real adafruit parts.
Users browsing this forum: No registered users and 1 guest