infill and support

General mintyPi-related chat goes here. Share ideas, ask questions that don't fit into the hardware/software help forums, etc.
Post Reply
Stitch mod
Posts: 5
Joined: Mon Mar 18, 2019 7:28 am
Has thanked: 1 time
Been thanked: 1 time

infill and support

Post by Stitch mod » Mon Mar 18, 2019 7:36 am

I don't know what infill to use and if i should sue support for the face plate

Cdiehl1980
Posts: 2
Joined: Thu Dec 06, 2018 8:38 pm
Has thanked: 3 times

Re: infill and support

Post by Cdiehl1980 » Tue Mar 19, 2019 10:51 am

I used 100% infill since they were smaller parts and didn't increase the print time that much. I flipped the faceplate so it was face down so no supports were needed.

User avatar
dryja123
Posts: 1014
Joined: Tue May 09, 2017 5:34 pm
Location: Central NJ
Has thanked: 230 times
Been thanked: 529 times

Re: infill and support

Post by dryja123 » Tue Mar 19, 2019 9:14 pm

Correct, flip the faceplate face down on the buildplate and don’t use supports.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest