infill and support
-
- Posts: 5
- Joined: Mon Mar 18, 2019 7:28 am
- Has thanked: 1 time
- Been thanked: 1 time
-
- Posts: 2
- Joined: Thu Dec 06, 2018 8:38 pm
- Has thanked: 3 times
Re: infill and support
I used 100% infill since they were smaller parts and didn't increase the print time that much. I flipped the faceplate so it was face down so no supports were needed.
- dryja123
- Posts: 1076
- Joined: Tue May 09, 2017 5:34 pm
- Location: Central NJ
- Has thanked: 239 times
- Been thanked: 553 times
Re: infill and support
Correct, flip the faceplate face down on the buildplate and don’t use supports.
Guide for troubleshooting mintyPi power problems: http://www.sudomod.com/forum/viewtopic.php?f=34&t=4115
My mintyPi builds: http://www.sudomod.com/forum/viewtopic.php?f=32&t=3985
My mintyPi builds: http://www.sudomod.com/forum/viewtopic.php?f=32&t=3985
Who is online
Users browsing this forum: No registered users and 1 guest