Page 1 of 1
infill and support
Posted: Mon Mar 18, 2019 7:36 am
by Stitch mod
I don't know what infill to use and if i should sue support for the face plate
Re: infill and support
Posted: Tue Mar 19, 2019 10:51 am
by Cdiehl1980
I used 100% infill since they were smaller parts and didn't increase the print time that much. I flipped the faceplate so it was face down so no supports were needed.
Re: infill and support
Posted: Tue Mar 19, 2019 9:14 pm
by dryja123
Correct, flip the faceplate face down on the buildplate and don’t use supports.