Screw Issue?

Having trouble with your mintyPi build? Post your questions here!
Post Reply
User avatar
mordecai131
Posts: 1
Joined: Tue Nov 27, 2018 11:12 pm

Screw Issue?

Post by mordecai131 » Tue Dec 04, 2018 9:13 pm

Are the screws supposed to slide into the pegs a bit before they begin to bite? The reason I ask is because even without the power board, sound board, and battery I can't seem to get the button face plate to screw down at all. Almost as if the screws are too short or I'm doing something wrong. Below is a link to a video showing what I'm talking about, and I'm sorry if the quality turns out to be trash. Thanks in advance!

https://drive.google.com/file/d/1vOWXB6 ... sp=sharing

User avatar
rodocop
Posts: 1348
Joined: Mon Aug 22, 2016 3:14 pm
Location: Saskatchewan
Has thanked: 520 times
Been thanked: 490 times

Re: Screw Issue?

Post by rodocop » Tue Dec 11, 2018 9:31 am

if the screws are loose, try wrapping them with some teflon tape, electrical tape or something to thicken them up a bit, that may help them bite in a bit. Depending on the 3d prints those screw holes may be slightly too wide due to the printer itself? Worst case, maybe put a small amount of hot glue inside the screw hole, and then once hardened, poke a small hole in the glue, and then screw the screws in. The glue should form the new threads for the screw.

Post Reply

Who is online

Users browsing this forum: No registered users and 24 guests