Tip: turn your tactile switches the right way

Having trouble with your mintyPi build? Post your questions here!
Post Reply
User avatar
Robochris
Posts: 310
Joined: Thu Feb 16, 2017 7:49 am
Location: Ohio
Has thanked: 82 times
Been thanked: 41 times

Tip: turn your tactile switches the right way

Post by Robochris » Fri Jul 28, 2017 6:59 pm

Maybe a 'duh' for others but I learned by doing.

I snipped off the two pins that weren't in use. The remaining portion of them made contact with the bottom of the tin. So I had an L button that was constantly "pressed".

Easy fix, just another time I had to take it apart.

MrDralixx
Posts: 56
Joined: Wed Jul 12, 2017 11:35 am
Has thanked: 7 times
Been thanked: 24 times

Re: Tip: turn your tactile switches the right way

Post by MrDralixx » Sun Aug 06, 2017 9:36 am

Not bad advice really.

I'm still building mine, but I opted to forgo shorting issues and took a few precautions.

1. I lined the inside edge of the base with electrical tape. I did this after drilling the holes needed. The tape fit perfectly between the bottom of the tin and the upper edge. I then poked the holes from the inside to out to expose tape. Then used the soldering iron (heated up) to melt the tape. Finally, I used the files for smoothing hole shapes to "pull" the melted edges of the tape from inside to out and scraped clean.

2. For the L/R buttons, I just used small strips of electrical tape around the connections. In hindsight, I probably should have used a small dab of hot glue or even some rubber cement. Oh well. Next time :)

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest