Button PCB Powering Woes

Having trouble with your mintyPi build? Post your questions here!
Post Reply
jeffersonbenson
Posts: 1
Joined: Wed Feb 28, 2018 7:05 pm

Button PCB Powering Woes

Post by jeffersonbenson » Wed Feb 28, 2018 8:01 pm

Hey everyone!
First time builder here (especially with anything of this complexity). I just finished getting everything all wired up, only to find that my pi wasn't receiving power from the Powerboost 500c (which is also monitoring the battery). I tried to follow all of the traces and everything is fine right up until it makes contact with the PCB, at which point the voltage drops (was about 3.3v, this evening read basically zero). My going theory right now involves my solder job to the PCB, but since I'm using an older board I figured I'd see if anyone else has any ideas, since I haven't seen this version of the button pcb before. Any advice helps. Thanks!

Close up of the area in question:
SpoilerShow
Image
Board front with version number:
SpoilerShow
Image
The whole setup:
SpoilerShow
Image

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests