sudomod

My first question is how do I make a custom button pcb? if making one is very hard then is there a place I can buy one for the minty pi! My second question is what is the object thanks!

If you don't know anything about that helping hand there then how do you expect to get into PCB making? It can be easy or hard depending on your level of familiarity with circuits and the software you plan to use to make them. Go look up some tutorial videos for Eagle CAD or Kicad and you will see what is involved.

Helder wrote: ↑

Fri Aug 03, 2018 3:32 pm

If you don't know anything about that helping hand there then how do you expect to get into PCB making? It can be easy or hard depending on your level of familiarity with circuits and the software you plan to use to make them. Go look up some tutorial videos for Eagle CAD or Kicad and you will see what is involved.

Sure I also figured out what things was (cable holder for soddering) and thank you for those applications although I want to buy a custom button pcb so would a "Gameboy DMG-01 4 Button PCB DIY Pi Zero" work for the minty pi? Here is the link https://www.ebay.ca/itm/Gameboy-DMG-01- ... m570.l1313
if not can you help me find one or tell me the name of a specific one meant for that button configuration? Because I don't want to spends months or years learning pcb design to get this board!

Better read around the forums then as I will have the new v3 in a few weeks to likely a month. You could just buy the expensive chinese knock off on ebay but you're on your own with any kind of support from me if you do.