Page 1 of 1
Maker paste
Posted: Thu Mar 07, 2019 7:24 pm
by IDon'tKnowWhatImDoing
Hi, so I had a quick question. Would the Adafruit Maker paste be a usable solution when connecting the PCB to the Pi in the v3 update? I just can't see myself getting a complete soldering station with the limited amount of money I have.
Re: Maker paste
Posted: Fri Mar 08, 2019 1:22 am
by Helder
Might work but you have to be super precise and not slather it on so there aren't shorts between GPIOs.
Re: Maker paste
Posted: Fri Mar 08, 2019 8:59 am
by IDon'tKnowWhatImDoing
Ok, thanks. That's what I needed.