V3 Input Configuration

[Shaggamathula]

Hello!

So I recently put together a V3 and was logging in some game play when I noticed when I hit the select + b it would reset the game. Since it's normally a hot key action is like to do some light troubleshooting and see if it's just the way the input is or it's a connectivity issue. Looking through the forums based on other issues I've seen chances are that it's either flux issue or a soldering issue. I did check continuity with all the pads multiple times before closing everything up.

I was thinking about running through the configure input screen and just go through that and see if the select and hot key buttons are same on there. I just don't know what the input would be for the star, screen "O" button, and if the power button is on this input screen.

I just want to make sure that don't mess it up to the point where a reflash is necessary.

[Helder]

If you look up retroarch hot keys you'd see that is a combo used to reset the game so nothing is wrong, select + some other button is usually a shortcut for some action within retroarch.