[For Sale, Preorder] DMG pre-cut cases

[neolith]

Oh crap, that looks like someone drove a car over your parcel!

[YaYa]

Hmmm... its look like the bulldozer test failed.

[jsawhite]

Got my case today! Looks great!!!!

20170819_202159748_iOS.jpg (2.31 MiB) Viewed 7513 times

20170819_202147770_iOS.jpg (2.33 MiB) Viewed 7513 times

[dryja123]

Hey Kubino,

Do you think you could cut rear button holes like Kite did in his Pi3 guide?

Also, I know other members asked as well, I'm planning on running dual PSP 1000 analog joysticks with the standard abxy button config with HoolyHoo's SAIO screen bracket. Is it possible for you to make joystick cuts?

I know I'm asking a lot but I have my Pi3 SAIO build all ready to go. I want my case to look as slick as possible.

Screenshot_20170819-181133.png (1.19 MiB) Viewed 7507 times

20170819_165521.jpg (3.88 MiB) Viewed 7505 times

[kubino]

Hi Corey,

joystick cut shouldn't be a problem. But rear buttons is a bit problematic for my CNC as it seems driling done via 45 degree angle. To achieve it I need another axist so it's much easier to do it in hand.

For now I can do just 90 degree cut and I'm not sure about the result

[Brag0n]

Suggestion/question:
What about cleaning out the battery bay?
(What i mean by that is removing the taps)
Would that be possible?

[YaYa]

Suggestion/question:
What about cleaning out the battery bay?
(What i mean by that is removing the taps)
Would that be possible?

And then, how do you close the shell and make sure that it won't open and let everything that is inside to fall outside ?

[dryja123]

Hi Corey,

joystick cut shouldn't be a problem. But rear buttons is a bit problematic for my CNC as it seems driling done via 45 degree angle. To achieve it I need another axist so it's much easier to do it in hand.

For now I can do just 90 degree cut and I'm not sure about the result

Thanks! I'm going to give they joystick cuts and button cuts a go myself. I picked up the step drill bit that Wermy uses. If I mess up I'll reach out for another order. Thanks!

[kubino]

Suggestion/question:
What about cleaning out the battery bay?
(What i mean by that is removing the taps)
Would that be possible?

I think it is possible. I already cut some small pieces to ensure galaxy s3 battery will fit

[Brag0n]

I mean, I would love to see how well it looks.
If he's able to mill something that is close to as clean or even cleaner than this

Then i might be very interested