[For Sale, Preorder] DMG pre-cut cases

[kubino]

received it today, what size screw is the small self tapper with the built in washer on the 6mm buttons? only had the center bolt and the screw on the left, right was missing

screw size is 1.7x5mm however 2x5 should be OK too, but you don't need it as the right side should be secured by SAIO backboard with screw included in package.

[sciisfun]

received it today, what size screw is the small self tapper with the built in washer on the 6mm buttons? only had the center bolt and the screw on the left, right was missing

screw size is 1.7x5mm however 2x5 should be OK too, but you don't need it as the right side should be secured by SAIO backboard with screw included in package.

aah, that makes sense, haven't done a dry assembly yet, didn't notice that

[jealouskain]

pm sent

[quaxar]

PM Sent, gonna be patient on when to use this on my 1UP all in one board.

[kubino]

PM replied, regarding 1UP kit, currently I don't have one so I cannot check which cuts are required.

[J-Malice]

Arrived here. Thanks man, looks good.

[cobramike]

Arrived here. Thanks again for your time.

[YaYa]

raaaah can't wait to have mine... chinese people please hurry up lol

[Marascon]

Did shoot you an email

[kubino]

raaaah can't wait to have mine... chinese people please hurry up lol

some cases already arrived, but I'm at work this week... If there is yours I'll ship early next week