Hi, welcome back
Approval is needed for new members, after that PM’s are fine. Sorry, I must have missed yours. Let me check and get back to you.
Hi, welcome back
You should be able to PMCrainium17 wrote: ↑Tue Dec 03, 2019 9:31 pmCan you check and see if I need approval? I've been gone for a bit and now back but can't get a response
I sent ya a pm, I was curious about some 3d parts.HoolyHoo wrote: ↑Wed Dec 04, 2019 3:10 pmYou should be able to PMCrainium17 wrote: ↑Tue Dec 03, 2019 9:31 pmCan you check and see if I need approval? I've been gone for a bit and now back but can't get a response
Thanks, PM should be working for you now
Any plans on releasing that .stl yet ?
Users browsing this forum: No registered users and 1 guest