[For Sale, Preorder] DMG pre-cut cases

[kubino]

I would be interested in the L/R bracket too if it ever becomes an option as well as the big button cutout.

I was thinking I create button wells for back case. But then you will need button assembly from cheap SNES controler like in this thread : http://www.sudomod.com/forum/viewtopic. ... 533#p39000

[StephenMcC]

A bracket for the big button cut out would be awesome, I have a few of the cheap snes controllers sitting at home

[kubino]

I was thinking about something bit different. what about 6mm 3d printed caps? Bracked is being designed

P_20170727_100846.jpg (1.26 MiB) Viewed 5628 times

P_20170727_100918.jpg (1.49 MiB) Viewed 5628 times

[StephenMcC]

Is it too late to get those?

[kubino]

Is it too late to get those?

not too late, if you don't mind waiting until I finish design

[StephenMcC]

I'm stuck waiting until September for my AIO so I don't mind waiting

[Eccho]

Guys, cutting your case is half the fun! It is really satisfying work!

[kubino]

Like I promised 3d printed bracket:

6mm L1,2/R1,2 BracketShow

bracket.png (25.28 KiB) Viewed 5604 times

P_20170727_150957.jpg (298.67 KiB) Viewed 5604 times

P_20170727_151020.jpg (1.25 MiB) Viewed 5604 times

P_20170727_151314.jpg (1.62 MiB) Viewed 5604 times

[StephenMcC]

Hey Kubino,

Can you cut my clear case with the 6mm buttons and include that bracket?

send me a PM with how much extra I need to send!

[neolith]

I just recieved my case.

The quality of the cutouts is quite impressive, they are very clean and straight. The edges are sharp, but not so much that you could cut your fingers on them.

Cutouts on the front part of the caseShow

Thanks kubino!