sudomod

I rehashed Adafruit's Micro Lipo, as seen in the Minti Pi project, to have a USB C connector, and a load balancer to let the battery charge faster. Right now this version is akin to the original Micro Lipo when it comes to functionality, as the original schematic is imported into my project.

Right now I only have 18 to sell. Because of that the price is inflated a bit to $16, but with the next batch hopefully it will be cheaper.

The default charge rate is the same at 100 mAh, with an increased charge rate of 500 mAh when a bridge is shorted.


You can purchase one of these over at Tindie: https://www.tindie.com/products/AWildTy ... o-charger/

Cute little board

moosepr wrote: ↑

Sat Mar 24, 2018 11:18 am

Cute little board

Thanks

I was lucky to be sent a prototype unit - worked well in my testing. Great job!

wermy wrote: ↑

Mon Mar 26, 2018 10:29 am

I was lucky to be sent a prototype unit - worked well in my testing. Great job!

Find anything to put it in yet?

AWildTyphlosion wrote: ↑

Mon Mar 26, 2018 1:13 pm

wermy wrote: ↑

Mon Mar 26, 2018 10:29 am

I was lucky to be sent a prototype unit - worked well in my testing. Great job!

Find anything to put it in yet?

I think I'd like to put together a mintyPi using it, if I can find the time.

wermy wrote: ↑

Mon Mar 26, 2018 1:17 pm

AWildTyphlosion wrote: ↑

Mon Mar 26, 2018 1:13 pm

wermy wrote: ↑

Mon Mar 26, 2018 10:29 am

I was lucky to be sent a prototype unit - worked well in my testing. Great job!

Find anything to put it in yet?

I think I'd like to put together a mintyPi using it, if I can find the time.

I'd love to see a completed version using it.