Page 1 of 2

[WANTED]: non-oem power switch and pot wheel

Posted: Sat Aug 13, 2016 9:11 am
by username 123
Hi fellow sudo modders! I am building a non-oem gbz and need two final pieces for my build. I need a power switch with the same throw length of the original power switch and one potentiometer volume wheel close to the same thickness of the oem wheel.

PM me what to have. I am located in the USA.
Thank you!

Re: [WANTED]: non-oem power switch and pot wheel

Posted: Sat Aug 13, 2016 1:00 pm
by sokignano
Honestly I got all of my small bits on Aliexpress and it ran about 29 with epacket shipping. But i made sure all the stuff I got was from the same seller. I got my shell, two sets of buttons, potentiometer (vol wheel), speaker, game cart for sd pcb, and two sets of slilcone rubber pads and it ran right at 25 bucks.

Re: [WANTED]: non-oem power switch and pot wheel

Posted: Sat Aug 13, 2016 11:21 pm
by username 123
Thanks. I'm more worried about getting a switch with a shorter throw. Someone posted up some switches that is a pretty close match but the seller doesn't ship to the USA.
Have you tried the switches you got?

Re: [WANTED]: non-oem power switch and pot wheel

Posted: Sun Aug 14, 2016 2:05 am
by sokignano
honestly, I broke down and looked for a broke DMG on ebay and found one with a carrying case and two games for 15 lol the shell is in great condition. and I plan to gut the stuff i need off of it. Power Switch, Cartridge connector, and headphone jack. everything else is going the way of the dodo :) But there was a guy that found a side mounted double pole single throw that is really close.

Re: [WANTED]: non-oem power switch and pot wheel

Posted: Sun Aug 14, 2016 6:06 am
by Camble
These are the switches I use.

The part number is SK22H03

Be careful. There are a few variants of this switch and the one pictured here may be discontinued. I ordered a bunch from Aliexpress and they sent a different switch. SK-22H07 is a suitable alternative.

Re: [WANTED]: non-oem power switch and pot wheel

Posted: Sun Aug 14, 2016 8:17 am
by sokignano
Thank you Camble for the information! Now, I wish i hadn't picked up the DMG off eBay lol. But username 123 if you are in the states just go to ebay.com and search for the part number Camble provided :)

Re: [WANTED]: non-oem power switch and pot wheel

Posted: Sun Aug 14, 2016 9:00 am
by username 123
I've already searched that part number on eBay and it only show two results. None of which look like the one posted here.

Re: [WANTED]: non-oem power switch and pot wheel

Posted: Sun Aug 14, 2016 9:15 am
by Camble
@username_123 There are a few variants of the switch, but the pins should be the same.

Searching eBay.com with the part number doesn't yield any results for me. Try searching for "DPDT slide switch" or look on Amazon.

Re: [WANTED]: non-oem power switch and pot wheel

Posted: Sun Aug 14, 2016 9:35 am
by sokignano
Is this the switch that we would need?

http://www.ebay.com/itm/20Pcs-6mm-High- ... SwdrRXGHJb

Re: [WANTED]: non-oem power switch and pot wheel

Posted: Sun Aug 14, 2016 10:19 am
by Camble
@sokignano Yes.