Looking for a 3D printed bracket for the power switch and mode button board for the new Kite CS. As far as I can tell, These boards have to be hot glued in place. I am going for an ultra clean and secure build with nearly ZERO hot glue, so having a bracket for that part would be excellent. I don't want to use hot glue as a primary mounting structure. I am mega OCD.
Note: I am using HoolyHoo's PSP joystick screen bracket for the standard 320 screen.
Ready to pay immediately if someone has designed such a piece. I saw a bracket mentioned somewhere but haven't been able to find one for sale. Thanks!
FOUND! (Mods can lock) WTB: 3D printed power switch board bracket for Kite CS (current).
-
- Posts: 52
- Joined: Fri Feb 23, 2018 10:17 pm
- Has thanked: 19 times
- Been thanked: 26 times
FOUND! (Mods can lock) WTB: 3D printed power switch board bracket for Kite CS (current).
Last edited by ZahcStarKiller on Fri Mar 02, 2018 4:19 am, edited 1 time in total.
-
- Posts: 52
- Joined: Fri Feb 23, 2018 10:17 pm
- Has thanked: 19 times
- Been thanked: 26 times
Re: WTB: 3D printed power switch board bracket for Kite CS (current).
Problem solved.
Mods can lock and/or delete.
Mods can lock and/or delete.
Who is online
Users browsing this forum: No registered users and 1 guest