3D Printed Power switch holder

[vinomer]

If I can get a board like the one in this picture that would work just as well. If not, then I'm looking to buy a 3D Printed holder for the power (on/off) switch.

[sygyzy]

I am very confused. What are you building exactly? The picture shows components from Kite's Circuit Sword kit. The 3d printed bracket you see pictured is made for that particular board/switch.

[vinomer]

Top left of the picture, under the board is a 3D Printed piece that holds the power switch, that's what I'm looking for (or something similar) . I don't want to just set my power switch there and hot glue it in place, so if I have a piece under it, it'll hold and look better. I'm trying to stay away from using hot glue.

[Italian77]

That is HoolyHoo’s part. You can find it on the forums.

https://www.sudomod.com/forum/viewtopic.php?f=58&t=5321


If you also need the fan cartridge that you show in that pic as well then you will need the modified power switch bracket that goes with it. HoolyHoo makes that as well.

That can also be found here.

https://www.sudomod.com/forum/viewtopic.php?f=58&t=5700

[sygyzy]

Top left of the picture, under the board is a 3D Printed piece that holds the power switch, that's what I'm looking for (or something similar) . I don't want to just set my power switch there and hot glue it in place, so if I have a piece under it, it'll hold and look better. I'm trying to stay away from using hot glue.

This is still unclear to me. You are asking for the circuit board or the 3D printed piece? Having the piece won't help you if you don't have Kite's power switch board.