Page 1 of 1

mintyPi Tin Cutting Service (U.S. for start)

Posted: Sun Jul 30, 2017 4:44 pm
by dryja123
Hello everyone,

Reaching out to see if there's any interest in buying pre-cut mintyPi tins. I picked up a few Dremel bits that made the process extremely effortless.

If you're interested please post a comment below and let me know how many you'd like and what colors. If there's enough interest I'll put a price up and offer them for sale. I'm only going to offer standard colors that I can find in the supermarket.
20170730_175517.jpg
20170730_175517.jpg (5.01 MiB) Viewed 3312 times
20170730_175529.jpg
20170730_175529.jpg (5.37 MiB) Viewed 3312 times
(The green tin is a perfect cut. The red tin is a little wide on the charging port.)

Re: mintyPi Tin Cutting Service (U.S. for start)

Posted: Sun Aug 06, 2017 5:24 pm
by Pentium
Thanks for doing mine btw

Re: mintyPi Tin Cutting Service (U.S. for start)

Posted: Thu Aug 24, 2017 7:58 pm
by mtb1126
how much would these cost? I would rather not pay more than like $7-ish

Re: mintyPi Tin Cutting Service (U.S. for start)

Posted: Thu Aug 24, 2017 8:17 pm
by dryja123
mtb1126 wrote:
Thu Aug 24, 2017 7:58 pm
how much would these cost? I would rather not pay more than like $7-ish
Idk haven't really received any interest on the service. If there was demand I was going to buy empty tins in bulk off eBay. Is there a particular color you want? $2.50 for a tin of Altoids plus shipping adds up to about $7 so I'm doing you a favor. Let me know and if I get some free time I'll try to cut one for you.

Re: mintyPi Tin Cutting Service (U.S. for start)

Posted: Thu Aug 24, 2017 8:32 pm
by mtb1126
Good to know. I might take you up on that