Page 1 of 1

GBZ custom 3d parts. Pi3, volume knob, USB.

Posted: Sat Nov 10, 2018 9:39 am
by Kalei808
I haven't been on the forums in a long time but I have built over 30 gbz to date. I have created 3d parts that fit the helder aio and possibly other button pcb boards. It makes a much cleaner install and allows the pi0w to be removed easily later if need be. Has rear screw posts. USB and volume knob mounts. You will still need to use some hot glue but a lot less. Just wanting to see if there's any interest in these parts.

Re: GBZ custom 3d parts. Pi3, volume knob, USB.

Posted: Wed Nov 13, 2019 1:04 pm
by superman
I know no one has commented but i was wondering are you making these. If not could you share the stl it would be so helpful.