wiring prototype board to powerboost
- Camble
- Posts: 885
- Joined: Thu May 05, 2016 2:31 am
- Location: Scotland
- Has thanked: 269 times
- Been thanked: 488 times
Re: wiring prototype board to powerboost
After tinkering with it, I think I have the idea. All of the blacks need to be connected in one line and all of the reds need to be connected in one line?Camble wrote:@bammeh with wire or solder
- gargoyle67
- Posts: 73
- Joined: Fri Jun 17, 2016 3:13 pm
- Has thanked: 48 times
- Been thanked: 16 times
Re: wiring prototype board to powerboost
You need to join all the grounds in one line and 5v line in another line, i.e solder join them like in the tutorial video.bammeh wrote:Oxodao wrote:Theses are much cheaper and works also, that's what I use. You only need to wire the line yourself
http://www.ebay.co.uk/itm/10Pcs-DIY-Pro ... SwNSxVVtu0
How would you wire the line?
- Oxodao
- Posts: 131
- Joined: Wed Jun 01, 2016 11:35 am
- Location: 127.0.0.1
- Has thanked: 4 times
- Been thanked: 30 times
- Contact:
Re: wiring prototype board to powerboost
Yeah of course, that's how the original boards worksbammeh wrote:After tinkering with it, I think I have the idea. All of the blacks need to be connected in one line and all of the reds need to be connected in one line?Camble wrote:@bammeh with wire or solder
Arduino sketch for the gamepad (Teensy replacement): http://github.com/oxodao/GBZGamepad
Who is online
Users browsing this forum: No registered users and 1 guest