I've made a discovery! I am about 3/4 finished with my first gameboy zero, and I have realized that I don't have a 3D printer or any access to one.. What was I going to do about my X and Y Buttons? I started digging around one of my junk totes and found an old original Xbox S controller that I knew I wasn't going to be using any more, so I opened it up and started cutting away with my dremel tool. I should mention that I bought a button set from retromodding.com as well. Anyway, What I discovered is the actual buttons inside the xbox controller make a near perfect button well for a gameboy zero! I just cut the top off the xbox buttons and hollowed them out.
Materials Needed for mod:
-Original Xbox "S" controller
-Dremel tool
-Super Glue or Hot Glue
Hit me up on here if you have any questions or comments on this.
DIY Button Wells with no 3D Printer!!
Who is online
Users browsing this forum: No registered users and 1 guest