DIY Button Wells with no 3D Printer!!
Posted: Wed Feb 10, 2021 5:23 pm
I've made a discovery! I am about 3/4 finished with my first gameboy zero, and I have realized that I don't have a 3D printer or any access to one.. What was I going to do about my X and Y Buttons? I started digging around one of my junk totes and found an old original Xbox S controller that I knew I wasn't going to be using any more, so I opened it up and started cutting away with my dremel tool. I should mention that I bought a button set from retromodding.com as well. Anyway, What I discovered is the actual buttons inside the xbox controller make a near perfect button well for a gameboy zero! I just cut the top off the xbox buttons and hollowed them out.
Materials Needed for mod:
-Original Xbox "S" controller
-Dremel tool
-Super Glue or Hot Glue
Hit me up on here if you have any questions or comments on this.
Materials Needed for mod:
-Original Xbox "S" controller
-Dremel tool
-Super Glue or Hot Glue
- 149031213_791835261542680_4243875708716151284_n.jpg (122.1 KiB) Viewed 2997 times
- 148303832_431279878305403_5997387302892360188_n.jpg (159.93 KiB) Viewed 2997 times