sudomod

I have a glass screen protector that has a very narrow black border. The border is around half the width of the others I bought before I found it. I'm going to thin up the case edge it sits on as far as possible to maximize visible screen. It has the 3M backing they all have, but I'm concerned I need to shore that up to make sure it doesn't pop loose.

Anyone have any recommendations on how to do this? Or maybe it's not necessary and others have done as I plan to do with no issues. I certainly don't want to apply anything that will spread and cloud/obstruct past the black border.

Thanks!

Not sure how you would shore up the edge but 2mm tape all around is fine.