Question about membranes (X Y buttons)

General GBZ-related chat goes here. Share ideas, tips and tricks, or ask questions that don't fit into the hardware/software help forums.
Post Reply
cmdr_scotty
Posts: 1
Joined: Fri Sep 24, 2021 12:08 pm

Question about membranes (X Y buttons)

Post by cmdr_scotty » Fri Sep 24, 2021 12:12 pm

What are you using for the button membrane for the x/y buttons after adding them in?

Been searching through the forums and do find quite alot on the discussion of button types, and pcb's to use, but not really finding anything on how or what people are using for the membrane for the x/y buttons

Working on doing my own build and bought a pcb off ebay (says it's Helder's PCB v 1.3), and trying to figure out how to do the membrane for x and y.

User avatar
Spyder
Posts: 218
Joined: Mon Aug 26, 2019 3:07 pm
Has thanked: 6 times
Been thanked: 49 times

Re: Question about membranes (X Y buttons)

Post by Spyder » Mon Sep 27, 2021 8:51 am

Same one as the AB and just some trimming with scissors

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest