Page 1 of 2
kitsch-bent Cartridge PCB wiring
Posted: Thu Aug 25, 2016 2:00 pm
by tlxxxsracer
So I purchased:
http://store.kitsch-bent.com/product/kk_gb_zero_c
I'm trying to figure out which trace goes to which tab on the microSD card.
I'm not planning to have this removable. I'm going to wire up this directly to the piZero and there be a hollowed out cartridge with this mounted (saves space).
I just need to figure out what wires need to go to which pads on the zero and wire to the cartridge
Almost ready to start my build otherwise
waiting for all in one board
Re: kitsch-bent Cartridge PCB wiring
Posted: Thu Aug 25, 2016 3:04 pm
by BadBert
I would like to know this aswell!
Re: kitsch-bent Cartridge PCB wiring
Posted: Thu Aug 25, 2016 4:51 pm
by ABH
sorry i don't use it , but i think @wermy mention that in the tutorial .
but if you planning to wire up directly to the pi
this extensions will be easy and clean
http://www.ebay.com/itm/262417327051?_t ... EBIDX%3AIT
http://www.ebay.com/itm/Sintech-Micro-S ... xyjP1R0QCO
Re: kitsch-bent Cartridge PCB wiring
Posted: Thu Aug 25, 2016 7:10 pm
by tlxxxsracer
Not what I'm talking about.. I'm planning to just solder wires from the pizero to the cartridge I link in OP. But idk which pins on the cartridge adapter goes to which pads on the zero
Re: kitsch-bent Cartridge PCB wiring
Posted: Thu Sep 01, 2016 4:56 am
by tlxxxsracer
bueller...?
Re: kitsch-bent Cartridge PCB wiring
Posted: Sat Sep 03, 2016 7:24 am
by BadBert
anyone?
Re: kitsch-bent Cartridge PCB wiring
Posted: Sun Sep 04, 2016 4:29 am
by BadBert
Found the info in the sale topic of the cartridge from kitschbent!
Seems to work perfectly
Re: kitsch-bent Cartridge PCB wiring
Posted: Sun Sep 25, 2016 8:02 pm
by jdsanch
BadBert wrote:Found the info in the sale topic of the cartridge from kitschbent!
Seems to work perfectly
COuld you post a link to the info you found? Please
Re: kitsch-bent Cartridge PCB wiring
Posted: Mon Sep 26, 2016 12:44 am
by BadBert
jdsanch wrote:BadBert wrote:Found the info in the sale topic of the cartridge from kitschbent!
Seems to work perfectly
COuld you post a link to the info you found? Please
I Wired it up like this:
thanks to @Flowlance for the image
Works perfect!
Re: kitsch-bent Cartridge PCB wiring
Posted: Mon Nov 07, 2016 12:01 pm
by wolffman007
Would you happen to have a pic of what the cartridge reader looked like after you soldered it? I used the same pins of the cartridge reader as I would have used on the card itself.
I ran the same setup but was not able to successfully boot. I could only get the one raspberry to show up.
- IMG_3496.JPG (1.77 MiB) Viewed 9886 times
BadBert wrote:jdsanch wrote:BadBert wrote:Found the info in the sale topic of the cartridge from kitschbent!
Seems to work perfectly
COuld you post a link to the info you found? Please
I Wired it up like this:
thanks to @Flowlance for the image
Works perfect!