Problem with USB-Port (ROM&Conifg transfer)

[Phil]

EDIT: Problem is solved now. I just followed Helders steps how to solve it. http://www.sudomod.com/forum/viewtopic.php?t=1185
I also twisted the D+ and the D- wires and detwist the other ones

Hi guys,
right now I am in the final stage of my GBZ-Project. Everything is working fine, except my USB-Port for transferring the ROMs and config-files. And I may need your help. As you can see in the images below the port is (hopefully) wired as it should be. If I plug in my USB-stick its light is blinking for a short period of time. After 5 to 10 seconds the light stops it and starts glowing until it is plugged out. After that I restart my raspberry but there were not ROMs transferred. I have already checked the USB-stick with my raspberry before I start wiring it all up and back then it worked as it should. Inside the spoiler you will find how I wired the USB-port.

I know wires can influence each other because they “producing” electromagnetic fields (It is hard to explain for me since English isn’t my native language). Do you have any suggestions how I can prevent the USB-data from being influenced? Any help will be appreciated.

Greetings,
Phil

[spoiler="Wiring"][/spoiler]

[Helder]

Go to my support thread in my signature, the first post has info on how to setup the usb for certain devices in the config.txt.

You also need to twist the D+ and D- wires with each other not with 5v as you have done.