Adafruit screen + kb common ground pcb?

[401Gaming]

Ok so I'm looking into using the Kitsch bent common ground pcb for my buttons to make things a little neater and easier. My question is, will the X and y button locations on this pcb (rev. 1) get in the way of the bottom of the screen? Or are they still low enough to clear it

[Robots86]

You should be fine even if the screen was low ive found the pcb sits just above it. Im using a car tft rather than the adafruit though....

[Synnth3t1k]

Ok so I'm looking into using the Kitsch bent common ground pcb for my buttons to make things a little neater and easier. My question is, will the X and y button locations on this pcb (rev. 1) get in the way of the bottom of the screen? Or are they still low enough to clear it

I got the pcb from Kitsch-Bent. It will work perfectly fine. I sized it up with the pcb that I cut, then fried with my iron and it was a little bit shorter.