sudomod

I am trying to wire my audio circuit for my GBZ, but I can't figure out how to. Could anyone help me? I am using my own PWM audio board (http://market.sudomod.com/tiny-pi-zero-audio/), an Adafruit mono amp, and an Adafruit breadboard-friendly headphone jack. I also might be able to use the GBA headphone jack.

First of all I would wire the circuit up without the PWM filter, just to test it. Removes one layer of complexity IMO.

Assuming you have also wired the components to your PWM pcb?

Have you wired anything together as yet? If so, fire some pics on...

Another question, are you using Mono audio? If so then you'll only need 1x PWM output from Pi and to amend your Config.txt accordingly.

I am using mono audio and have assembled my PWM pcb. I would try to wire it together, but I can't figure out how.

See below for how I wired my audio. It shows the kitchbent PWM filter in there, but that can just be replaced by the one you have (your should have a L, R, and Ground in, and an out similar to what is seen in my diagram). Let me know if this helps. This was made following wermy's original guide and used the original headphone jack from the gameboy.

Thanks! I will try that when I get a chance.