Button Hole Size

Robots86 · Post by **Robots86** » Thu Jun 02, 2016 5:36 am

Can anyone tell me the width of the a/b button holes...? pref in mm. Thanks

Post by **Helder** » Thu Jun 02, 2016 5:55 am

Using my calipers gives me 10.8mm .

Robots86 · Post by **Robots86** » Thu Jun 02, 2016 6:06 am

Helder wrote:Using my calipers gives me 10.8mm .

Thanks Helder Going to pick up a screw bit for version 2 on my way home. Want to try and get a cleaner hole this time

LoafSlice · Post by **LoafSlice** » Thu Jun 02, 2016 10:11 am

what a strange size, How are you going to do it?

LoafSlice · Post by **LoafSlice** » Thu Jun 02, 2016 10:11 am

Helder wrote:Using my calipers gives me 10.8mm .

I think on your template you put a 3/8ths? or something

Post by **Helder** » Thu Jun 02, 2016 1:54 pm

Yes that's what I used because it's what I had on hand but the actual size of the original buttons on the case is the 10.8mm.

Robots86 · Post by **Robots86** » Fri Jun 03, 2016 4:31 am

I purchased a set of drill bits last night. Went with a 10.5mm drill bit. Used my hands rather than a drill so i could slowly turn for precision and then used a smaller bit with some sandpaper wrapped around to clean it up and get the correct size. looks a lot better than my last attempt

Button Hole Size

Button Hole Size

Re: Button Hole Size

Re: Button Hole Size

Re: Button Hole Size

Re: Button Hole Size

Re: Button Hole Size

Re: Button Hole Size

Who is online