sudomod

Can anyone tell me the width of the a/b button holes...? pref in mm. Thanks

Using my calipers gives me 10.8mm .

Helder wrote:Using my calipers gives me 10.8mm .

Thanks Helder Going to pick up a screw bit for version 2 on my way home. Want to try and get a cleaner hole this time

what a strange size, How are you going to do it?

Helder wrote:Using my calipers gives me 10.8mm .

I think on your template you put a 3/8ths? or something

Yes that's what I used because it's what I had on hand but the actual size of the original buttons on the case is the 10.8mm.

I purchased a set of drill bits last night. Went with a 10.5mm drill bit. Used my hands rather than a drill so i could slowly turn for precision and then used a smaller bit with some sandpaper wrapped around to clean it up and get the correct size. looks a lot better than my last attempt