Status LEDs / drilled holes on case or cartridge
Posted: Tue Feb 27, 2018 10:49 pm
Hi guys
I'm doing research into builds where people have drilled four small holes in the top of their case, or sometimes in the cartridge at the back, and mounted the four status LEDs of the kite board. I remember one thread mentioning taping down the case with kapton tape? Modifying the HoolyHoo bracket to accommodate the LEDs?
My problem is, I stumbled upon this info a thousand messages and threads ago and now can't find the relevant info. So if it's your build, or you did this or know which thread I'm banging on about, can you pls PLS provide a link
And, for Kite, or for anyone else that knows... are the holes to see the SMDs on the CS board itself, or are these types of projects where people are replacing those status LEDs with their own, thus extending the LEDs to the case exterior?
Anyway, its almost 1am... fairly sure I should sleep at some point...
I'm doing research into builds where people have drilled four small holes in the top of their case, or sometimes in the cartridge at the back, and mounted the four status LEDs of the kite board. I remember one thread mentioning taping down the case with kapton tape? Modifying the HoolyHoo bracket to accommodate the LEDs?
My problem is, I stumbled upon this info a thousand messages and threads ago and now can't find the relevant info. So if it's your build, or you did this or know which thread I'm banging on about, can you pls PLS provide a link
And, for Kite, or for anyone else that knows... are the holes to see the SMDs on the CS board itself, or are these types of projects where people are replacing those status LEDs with their own, thus extending the LEDs to the case exterior?
Anyway, its almost 1am... fairly sure I should sleep at some point...