Anyone is using the Adafruit MAX98357 I2S Class-D Mono Amp with his gameboy zero?
I added the I2S amplifier to it on the recommended pins, followed the instructions to setup the system to use it but when the only thing it does is low noise static, followed by silence when I play a sound. Any idea?
I use the latest retropie and haven't found any information is there is any incompatibility issue anywhere or any similar posts. I also connected the SD pin to a switch to turn it off in needed. Even when its not playing sound, I measured +350mA consumption, I soldered a second one I had just to verify it was not burned or shorted, but has same behavior.
Any suggestions are welcome
General GBZ-related chat goes here. Share ideas, tips and tricks, or ask questions that don't fit into the hardware/software help forums.
1 post • Page 1 of 1
- Posts: 143
- Joined: Tue Jun 07, 2016 4:26 pm
- Has thanked: 95 times
- Been thanked: 67 times
Who is online
Users browsing this forum: No registered users and 1 guest