Bottom mounted HDMI port
-
- Posts: 2
- Joined: Thu Jun 14, 2018 2:37 pm
Bottom mounted HDMI port
Is it possible to relocate the HDMI port to the bottom of the Gameboy shell? I'm about to begin my first build and I was thinking of making a Qi charging stand with a HDMI jack on the bottom of the stand. I found these HDMI ports with the ribbon that look like they may fit below the PCB.
That would allow me to charge and connect HDMI to the television without wires all over the place. Any thoughts or suggestions? Also would I have more room with a GBZ build or a CM3 build with Kites PCB?- KonnorJ
- Posts: 385
- Joined: Thu Jan 11, 2018 1:23 am
- Location: United Kingdom
- Has thanked: 58 times
- Been thanked: 109 times
- Contact:
Re: Bottom mounted HDMI port
You can get hdmi extensions and cut a whole in the bottom of the case for the shell. Wire management might be a bit more tricky but it's definitely doable.
Who is online
Users browsing this forum: No registered users and 1 guest