Where does this 3d hoolyhoo part go?

[Slimpreaper]

Sorry wasnt exactly sure where to post this.

Does anyone know where this hoolyhoo 3d printed part goes?

I bought the following 3d parts from him
Screen bracket (6 button)
Fan vent
Power switch support

Thanks for your help

[Deen]

Looks like Erics back bracket, I think.

[Hellweaver666]

Looks like Erics back bracket, I think.

Nah, I just printed one of those... it's more egg shaped (unless it's changed!).

[HoolyHoo]

Sorry wasnt exactly sure where to post this.

Does anyone know where this hoolyhoo 3d printed part goes?

I bought the following 3d parts from him
Screen bracket (6 button)
Fan vent
Power switch support

Thanks for your help

It is used to secure the CM3 Fan cart to the case. If you have the fan cart slid in the shell, looking at it from the top, that piece goes from the right post of the cart to the existing screw hole mount on the shell. It bridges to hold the cart in place. The left side of the cart is held as well with the opposite post of the cart to the power mode tab. Maybe this image will help to visualize it.

FanCart.png (265.58 KiB) Viewed 4882 times

[Slimpreaper]

Perfect thanks!