You helped with my VGA configuration.Ganreizu wrote:(i don't quite remember off hand specifically what i did but thank you regardless hahaha)
DirtyBeagles Build/Progress GBZ (Completed)
- dirtybeagles
- Posts: 386
- Joined: Thu May 05, 2016 6:04 am
- Has thanked: 34 times
- Been thanked: 64 times
Re: DirtyBeagles Build/Progress
- dirtybeagles
- Posts: 386
- Joined: Thu May 05, 2016 6:04 am
- Has thanked: 34 times
- Been thanked: 64 times
Re: DirtyBeagles Build/Progress
Added my GBZ diagram without pads (I might add the later, not sure). Enjoy.
FYI: I do get stereo from the speaker and the headphone jack with this setup. After several retrys
edit: forgot to thank [mention]Cannikin[/mention] for help with the pictures.
FYI: I do get stereo from the speaker and the headphone jack with this setup. After several retrys
edit: forgot to thank [mention]Cannikin[/mention] for help with the pictures.
- DirtyBullets
- Posts: 137
- Joined: Tue May 17, 2016 4:05 pm
- Location: Lowestoft, UK
- Has thanked: 5 times
- Been thanked: 42 times
- Contact:
Re: DirtyBeagles Build/Progress
ah ha, audio schematic just what i need to finish the PI3, oh wait i forgot the speaker...DAM IT!!!! better order one...
Re: DirtyBeagles Build/Progress GBZ (Completed)
Hi dirtybeagles,
In your schematic it seems that you connected the switch pin of your audio amp to the 5V GPIO of the Pi0 and the 5V input of the amp to switch A on the headphone jack which itself is connected to ground on the amp. Could you elaborate how this works?
I am using an amp for the speaker only (without the switch pin though) and I am having some trouble with interference/noise. Note that I am powering the amp directly from the powerboost.
Thanks
m0rphman
In your schematic it seems that you connected the switch pin of your audio amp to the 5V GPIO of the Pi0 and the 5V input of the amp to switch A on the headphone jack which itself is connected to ground on the amp. Could you elaborate how this works?
I am using an amp for the speaker only (without the switch pin though) and I am having some trouble with interference/noise. Note that I am powering the amp directly from the powerboost.
Thanks
m0rphman
Who is online
Users browsing this forum: No registered users and 1 guest