Hawker's Gameboy Zero

[hawker180]

Finally back to my project, after having so many issues trying to get my thing to close I have taken a couple of steps back and have decided to start again.

I have purchased a 3d Printer and found Bluechips designs on thingiverse, so credit to him and also Wermy. Here is my combined screen surround, button guides and also screw tower 3d printed design:

mount.JPG (116.29 KiB) Viewed 6651 times

If you have your own printer the STL is available here:
http://www.thingiverse.com/thing:1815950

I also have the all in 1 board ready to go in as well.

[hawker180]

After having all sorts of issues trying to close mine up I am pretty much starting again. The idea is to not use as much hot glue this time a d utilise my 3d printer

[Mischief]

Did your combined screw bracket and screen surround work ok as I am thinking of getting one printed.

Thanks

[hawker180]

Did your combined screw bracket and screen surround work ok as I am thinking of getting one printed.

Thanks

Hey Mischief, it seems to have worked really well for my screen setup anyway. The button holes are a little tight and needed a bit of a file out.

[Mischief]

Did your combined screw bracket and screen surround work ok as I am thinking of getting one printed.

Thanks

Hey Mischief, it seems to have worked really well for my screen setup anyway. The button holes are a little tight and needed a bit of a file out.

Great thanks, I am also trying to use less to no hot glue in my next GBZ that AIO screen surround will help a lot i'm trying to make it so all components are removable making it easier to replace broken parts.