Hi all,
This is pretty early in the build process, and I'm taking my time. But I figured I'd share.
Because I can't do anything the easy way, I want to use Kite's CSO with his 640x480 LCD. So I'm printing a case that's just a little wider than a DMG to accommodate the slightly wider screen. While I'm at it, I'm squeezing in Adafruit's 6600mAh battery.
Four prints in, and I have the PCB mounted to the case, with start, select, abxy and the dpad all working.
I still need to figure out how I'm going to screw the case together, and design a fan duct for the back. Oh, and expose the ports and micro-SD card. They're going to have to be recessed because of the wider case.
Here are some photos.
Tinker's Printed CSO Build
- ThompsonTinkers
- Posts: 39
- Joined: Sat Jan 28, 2017 9:36 pm
- Has thanked: 57 times
- Been thanked: 20 times
Who is online
Users browsing this forum: No registered users and 1 guest