It is a nice maschine after all the different Pi Zero's I did up to now. This maschine is amazing fast compared to the Pi0`s.
The build is nothing special. My adaptations:
Analog stick: I chose lower left side since this bracket was easier to print for me. Just too late I recogniced the psp1000 plastic washer for dust protection is chaffing on the housing but I could manage to remove this part my quezing and cutting from outside without the need of disassemble the board again. (By the way: for N64 settings I need to swap analog L and R)
Fir the QI charging: just a nice feature I wanted to have
![Wink ;-)](./images/smilies/icon_e_wink.gif)
The upper holes for LED indication with hotglue went not too bad. For a better finish I cleaned the outside with alcohol and reheated carfully the surface/glue buy hotair at 200° celsius.
I did not take any pictures from the inside but all brackets are 3d printed, thanks on all the uses here which published there files to the community! All internal brackets screws are from the "Laptop kit" mentioned for MintyPi.
Edit: pictures added.