SNES themed Kite's Circuit Sword Lite build with no glue or tape

[Yawn]

Could you share your STL files?

They’re attached to the first post. It’s one STL with everything included, but it’s easy to split that up in a the slicer.

[bentresearch]

Any chance for a 6 button or joystick variation?

[No Hands 55]

Was also thinking, what about having the screws on the sides? i know there is a bit of stuff on each side, but it looks like it would be possible to fit them in right near each post, facing out left and right. Currently printing your brackets and i have to say this screen bracket looks BY FAR the best. the taper of the posts on the right, the button well rims allowing for the silicone pad to sit, the proper silicone prong tabs for the backboard, etc. fantastic job

[Yawn]

Was also thinking, what about having the screws on the sides? i know there is a bit of stuff on each side, but it looks like it would be possible to fit them in right near each post, facing out left and right.

You know, I think you're right. Originally, I was going to rely on using the CS lite itself to hold the screen bracket down, but it wasn't quite firm enough for me. Some side fixings might give it enough strength. There's not a lot of space around the CS board to make it fit, though.

I had a quick go at adding that option, but be warned, I haven't tested this at all, and I had do judge the available gap by eye from my earlier photographs. I don't have any more DMG cases to test it on, and I know the width of the bracket isn't 100% perfect already, so the drafts I've added to the side might need a bit of adjustment.

Let me know how you get on.

[No Hands 55]

cool i might give this a try! i just made a CS CM3 with your brackets and they worked out wonderfully, just had to cut the top screw area off the screen bracket. for that reason i think i over estimated the room for side placed screws with a CS CM3, but ill still check it out.

Really great job though man everything fit sooooo much better with you back button brackets and screen brackets. appreciate it!

[smoothoperator]

Can you please do a 6 button version? It would be an awesome addition to the community.

[hawker180]

Can you please do a 6 button version? It would be an awesome addition to the community.

Let me know Yawn if you want me to remove it, But I modified your design and added the extra buttons. STL attached.

Thanks so much for all of your efforts with this one, great design!

[FireFoxGR]

Great idea Yawn! Nice work

is there any chance you can design a bracket for a 640x480 screen?

[spacemishka]

i have on question. Could make a seperate file for each component? It would be much easier to print.

thanks:)

[Yawn]

You should be able to delete the bits you don’t want to print in your slicer... I used Slic3r PE, which seemed to give the best prints, but was a pig to use, and needed lots of tweaks to the settings. Otherwise, try Cura?

If I have some time at the weekend I’ll try to split them up and post them.

On the subject of 6-button variants, I’m not sure exactly where the buttons should go. I think the spacing won’t be quite right if I rotate a pair of pads by 90 degrees. But anyone can feel free to give it a try in Fusion 360 - it’s free!