ahh i see now, no they are just traces tapped and some have been drilled so the wire can be put though to a tracer to avoid wire flapping around the button domes, TBH i didn't do this as i had my work mate (also a member of this forum) @banjokazooie did this for me because he had better solder equipment than i do, will dig to see if i have any more pics for yaFleder wrote:It looks like you drilled a hole and covered it with solder.
Like the pins/holes on the teensy, for example. Or were they already there on your PCB?
Since i did not have that holes in those places on my original board, i thought they were made by you.
D56: GameBoy Pi Zero
- DirtyBullets
- Posts: 137
- Joined: Tue May 17, 2016 4:05 pm
- Location: Lowestoft, UK
- Has thanked: 5 times
- Been thanked: 42 times
- Contact:
Re: D56: GameBoy Pi Zero
- DirtyBullets
- Posts: 137
- Joined: Tue May 17, 2016 4:05 pm
- Location: Lowestoft, UK
- Has thanked: 5 times
- Been thanked: 42 times
- Contact:
Re: D56: GameBoy Pi Zero
Hiya, do you have any information to extend from the powerboost to an LED? was thinking about installing and LED where the original 3v jack was supposed to go. Do you just solder from the low battery pad on the bottom of the powerboost?
Who is online
Users browsing this forum: No registered users and 1 guest